Flash Steam Traps

By 21 September 2015

A flash trap (see Figure 10-34) is used to drain condensation from steam lines; steam, water, and oil heaters; unit heaters; and other equipment in which the pressure differential between the steam supply and condensation return is 5 psig or more.

The operation of a flash trap depends upon the property of condensation at a high pressure and temperature to flash into steam at a lower pressure. The condensation flows freely through the trap due to the pressure difference between the inlet and outlet orifices. The free flow of the condensation is interrupted by the introduction of steam into the inlet chamber, where it mixes with the remaining condensation. The steam heats the condensation and causes it to flash, thereby temporarily halting its flow through the orifice and allowing it to accumulate in the trap.

Except for an adjustable orifice used for adjusting the pressure differential, a flash trap contains no other moving parts. Flash traps operate intermittently. They are generally available for pressures ranging from vacuum to 450 psig.